Linux version 2.6.23.17_stm23_A25C-SAT7111_7111-STSDK (d27lwj@LinuxServer3) (gcc version 4.2.4 (snapshot) (STMicroelectronics/Linux Base 4.2.4-55)) #131 PREEMPT Mon Oct 25 14:36:07 CST 2010
Booting machvec: sat7111
Entering add_active_range(0, 262144, 294912) 0 entries of 1 used
Node 0: start_pfn = 0x40000, low = 0x48000
Zone PFN ranges:
  Normal     262144 ->   294912
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0:   262144 ->   294912
On node 0 totalpages: 32768
  Normal zone: 256 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 32512 pages, LIFO batch:7
  Movable zone: 0 pages used for memmap
STMicroelectronics sat7111 initialisation
STx7111 version 3.x
Built 1 zonelists in Zone order.  Total pages: 32512
Kernel command line: console=ttyAS0,115200 stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 root=/dev/nfs nfsroot=192.168.0.85:/home/d52lz/workspace/target,nfsvers=2,rsize=4096,wsize=8192,tcp rw ip=192.168.0.84:192.168.0.85:192.168.0.1:255.255.0.0:LINUX7111:eth0:off bigphysarea=4000 nwhwconf=device:eth0,hwaddr:24:00:08:00:00:3C Manufacture=Spark-Project STB_ID=09:00:08:00:00:00:3C
bpa2: partition 'bigphysarea' created at 0x41100000, size 16000 kB (0x00fa0000 B)
PID hash table entries: 512 (order: 9, 2048 bytes)
Using tmu for system timer
Using 25.000 MHz high precision timer.
Console: colour dummy device 80x25
console [ttyAS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 98176k/131072k available (3628k kernel code, 988k data, 136k init)
PVR=04909200 CVR=60880000 PRR=00009a10
I-cache : n_ways=2 n_sets=512 way_incr=16384
I-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
D-cache : n_ways=2 n_sets=512 way_incr=16384
D-cache : entry_mask=0x00003fe0 alias_mask=0x00003000 n_aliases=4
Calibrating delay loop... 295.93 BogoMIPS (lpj=147968)
Mount-cache hash table entries: 512
CPU: STx7111
NET: Registered protocol family 16
fulanid: 09:00:08:00:00:00:3C
Generic PHY: Registered new driver
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Time: SuperH clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
Freeing initrd memory: 2430k freed
NTFS driver 2.1.28 [Flags: R/W].
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
fuse init (API version 7.8)
JFS: nTxBlock = 786, nTxLock = 6293
yaffs Oct 13 2010 14:56:15 Installing. 
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
STMicroelectronics ASC driver initialized
stasc.0: ttyAS0 at MMIO 0xfd032000 (irq = 121) is a stasc
stasc.1: ttyAS1 at MMIO 0xfd033000 (irq = 120) is a stasc
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: module loaded
stmmacphy_dvr_probe: added phy for bus 0
STMMAC driver:
	platform registration... <7>done!
	GMAC - user ID: 0x10, Synopsys ID: 0x33
	no valid MAC address; please, set using ifconfig or nwhwconfig!
	eth0 - (dev. name: stmmaceth - id: 0, IRQ #133
	IO base addr: 0xfd110000)
	Registering MDIO bus (id: 0)...
calling mdiobus_register
stmmac_mdio_reset: called!
stmmac_mdio_reset: calling phy_reset
mdiobus_register: found PHY and assigning IRQ -1
STMMAC MII Bus: probed
calling mdiobus_register done
eth0: PHY ID 00008201 at 2 IRQ -1 (0:02) active
	MDIO bus registered!
Davicom DM9161E: Registered new driver
Davicom DM9161A: Registered new driver
Davicom DM9131: Registered new driver
STe100p: Registered new driver
STe101p: Registered new driver
pegasus: v0.6.14 (2006/09/27), Pegasus/Pegasus II USB Ethernet driver
usbcore: registered new interface driver pegasus
usbcore: registered new interface driver asix
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver net1080
usbcore: registered new interface driver zaurus
nwhw_config: (eth0) setting mac address: 24:00:08:00:00:3C
physmap platform flash device: 02000000 at 00000000
physmap-flash: Found 1 x16 devices at 0x0 in 16-bit bank
physmap-flash: Found an alias at 0x800000 for the chip at 0x0
physmap-flash: Found an alias at 0x1000000 for the chip at 0x0
physmap-flash: Found an alias at 0x1800000 for the chip at 0x0
 Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
RedBoot partition parsing not available
Using physmap partition information
Creating 3 MTD partitions on "physmap-flash":
0x00000000-0x00080000 : "Boot firmware"
first erase region 0 for slave @ 0
0x00080000-0x00780000 : "Kernel"
first erase region 0 for slave @ 524288
0x00780000-0x00800000 : "Reserve"
first erase region 0 for slave @ 7864320
NAND device: Manufacturer ID: 0xad, Chip ID: 0xdc (Hynix NAND 512MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 2672 at 0x14e00000
Creating 4 MTD partitions on "gen_nand.1":
0x00000000-0x00800000 : "Spark kernel"
0x00800000-0x18000000 : "Spark Userfs"
0x18000000-0x18800000 : "E2 kernel"
0x18800000-0x1ff00000 : "E2 Userfs"
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
stm-ehci stm-ehci.0: st-ehci
stm-ehci stm-ehci.0: new USB bus registered, assigned bus number 1
stm-ehci stm-ehci.0: irq 169, io mem 0xfe1ffe00
stm-ehci stm-ehci.0: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
stm-ohci stm-ohci.0: stm-ohci
stm-ohci stm-ohci.0: new USB bus registered, assigned bus number 2
stm-ohci stm-ohci.0: irq 168, io mem 0xfe1ffc00
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for cp2101
usbcore: registered new interface driver cp2101
drivers/usb/serial/cp2101.c: Silicon Labs CP2101/CP2102 RS232 serial adaptor driver v0.07
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI USB Serial Device
usbcore: registered new interface driver ftdi_sio
drivers/usb/serial/ftdi_sio.c: v1.4.3:USB FTDI Serial Converters Driver
drivers/usb/serial/usb-serial.c: USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
drivers/usb/serial/pl2303.c: Prolific PL2303 USB to serial adaptor driver
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
STMicroelectronics - Coprocessors st231 Init
st-coprocessor-0: No RAM reserved
st231.0 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
st-coprocessor-1: No RAM reserved
st231.1 Coprocessor -------------------------------------------
    not configured!
---------------------------------------------------------------
stm_rng hardware driver 1.0 configured
heartbeat: version 0.1.1 loaded
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
ieee80211: 802.11 data/management/control stack, git-1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation <jketreno@linux.intel.com>
ieee80211_crypt: registered algorithm 'NULL'
ieee80211_crypt: registered algorithm 'WEP'
ieee80211_crypt: registered algorithm 'CCMP'
ieee80211_crypt: registered algorithm 'TKIP'
stmmac_init_phy:  trying to attach to 0:02
stmmac_init_phy:  eth0: attached to PHY (UID 0x8201) Link = 1
stmmac_timer: TMU2 Timer ON (freq 256Hz)
IP-Config: Complete:
      device=eth0, addr=192.168.0.84, mask=255.255.0.0, gw=192.168.0.1,
     host=LINUX7111, domain=, nis-domain=(none),
     bootserver=192.168.0.85, rootserver=192.168.0.85, rootpath=
RAMDISK: Compressed image found at block 0
RAMDISK: incomplete write (-28 != 32768) 4194304
Looking up port of RPC 100003/2 on 192.168.0.85
PHY: 0:02 - Link is Up - 100/Full
Looking up port of RPC 100005/1 on 192.168.0.85
VFS: Mounted root (nfs filesystem).
Freeing unused kernel memory: 136k freed
